To Next PageTo Next PageHow to reset Ambient Weather Alarm Clock that does not respond?
If your Ambient Weather Alarm Clock isn't responding to commands, use an open-ended paper clip or sharp tool to press the reset button on the back of the clock.
Why is my Ambient Weather Alarm Clock sensor not syncing?
If your Ambient Weather Alarm Clock sensor isn't syncing, there could be several reasons. First, ensure the transmitter is powered on and the LED is flashing about once per minute. If it's cold, try lithium batteries. If the transmitter isn't flashing, replace the batteries. The sensor might be too far (over 150 feet) or too close (less than 5-10 feet) to the clock. Try moving the sensor closer or further away. Also, make sure there are no solid metal or earth barriers blocking the signal. Electrical devices may also interfere, so keep the clock away from computers, TVs, and other wireless devices. Radio Frequency sensors cannot transmit through metal or thick walls. You may also try to resync the console.
What to do if my Ambient Weather Alarm Clock projection is fuzzy?
If the projection on your Ambient Weather Alarm Clock is fuzzy, simply adjust the focus setting.
General| Display Type | LCD |
|---|---|
| Sensor Transmission Frequency | 433 MHz |
| Snooze Function | Yes |
| Backlight | Yes |
| Power Source | AC adapter |
| Outdoor Temperature Range | -40°F to 140°F (-40°C to 60°C) |
| Indoor Humidity Range | 10 to 99% |
| Outdoor Humidity Range | 10 to 99% |
| Wireless Range | 300 feet line of sight |
| Temperature Display | °F or °C selectable |
| Humidity Display | Yes |
| Time Format | 12/24 hour |
Overview of the clock's main features and capabilities.
Details and components of the main clock display interface.
Information about the wireless transmitter, its components, and setup.
Lists all components included with the clock system.
Step-by-step instructions for powering on the transmitter and the clock.
Recommendations for optimal placement of the outdoor wireless sensor.
Description of the standard display mode, showing time, date, and weather data.
Guide to configuring the clock's time, date, and language preferences.
Instructions for setting and managing alarms on the clock.
How to activate, silence, and use the snooze feature for alarms.
Details on adjusting the projector and controlling the backlight brightness.
How to reverse the projected display by 180 degrees.
Instructions for focusing the projected time and temperature display.
Configuration and display options for barometric pressure readings.
How to switch between different units for barometric pressure (hPa, inHg, mmHg).
Explanation of absolute and relative pressure readings and how to switch them.
Steps to calibrate the relative barometric pressure for accurate local readings.
Understanding the barograph feature for predicting weather trends from pressure changes.
How to view and reset the recorded minimum and maximum temperature/pressure data.
Accessing and viewing historical weather data collected over the last 72 hours.
Overview of the LCD backlight color options and controls.
Setting a specific backlight color using MANUAL, RAINBOW, or TUNE buttons.
How the backlight color changes automatically based on outdoor temperature.
Adjusting backlight intensity or turning it off using the slide switch.
Understanding the icons and information shown for the wireless sensor on the clock display.
Identifying the low battery icon and instructions for battery replacement.
How to switch between or automatically scroll through multiple wireless sensor channels.
Troubleshooting steps for lost sensor signals and re-establishing communication.
Procedure for adding additional wireless sensors to the system, including console reset.
Technical details on wireless transmission range, frequency, and update rate.
Specifications for accuracy, range, and resolution of measured parameters.
Information on the power requirements for the display and wireless transmitter.
