installation instructions v1.3
SPECIFICHETECNICHE/ SPECIFICATIONS/ SPECIFICATIONSTECHNIQUES
Alimentazione / Input Voltage
Consumo / Current Drain (Alarm/Stand-By)
(18 mA / 26mA) @ 13.8 Vdc
Portata in lunghezza / Coverage
Portata in larghezza / Angle
Microonda classe ricevitore / microwave receiver class
Lente (fasci e livelli) / Lens (beams and levels)
Durata allarme / Alarm period
Antiapertura / Anti-opening
Contatto di allarme / Alarm’s Contact
Contatto di tamper / Tamper Switch
Temperatura di esercizio certificata / certified operating Temperature
RFI Protezione / Protection
Led WALK TEST (MW and PIR)
EN 50131-2-4 Grade 2 Class 2
Installation must be carried out following the local installation norms by qualified personnel.
The manufacturer refuses any responsibility when changes or unauthorized repairs are made to the product/system.
It is recommended to test the operation of the alarm product/system at least once a month. Despite frequent testing and
due to, but not limited to, any or all of the following: tampering, electrical or communication disruption or improper use, it
is possible for the product/system to fail to prevent burglary, rubbery, fire or otherwise. A properly installed and maintained
alarm system can only reduce the risk that this happens.
To Previous Page
Loading...
Need help?
General