installation instructions v1.3
4
3
2
0
1
1
2
3
4
0 1 2 3 4
5
unit: meters
1
0
2°
-2°
1
0 1 2 3 4
5
Note: You can request the sensor with the lens perpendicular orientation
see the picture above.
NOTE: do not cover, partially or completely, the field of vision of the detector
Alarm from one direction* (not IMQ certified)
*
To use the directional system optimally, you need to be inserted into the lens on the pyroelectric element separator
(see figure) and install it paying attention to the direction selection (dip-swtch5)
4.
INSTALLATION AND CONNECTION
Choose a suitable location, mount the sensor using the turrets tear to get the tamper protection.
The cable can go from a tiny hole next to the terminals, or if the section is very large, you can switch from the knock-out
(see figure below)
To Next Page
Loading...