installation instructions v1.3
TAMPER:
TAMPER ANTIOPENING LINE - 400mA 40Vdc
ALARM: ALARM CONTACT 100 mA - 40 V - 16 Ω
SUPPLY:
13.8Vcc 26mA Max
Fixed base rear slide the cable through the holes selected, secure the board in its housing interlocking and fix the cables
into the appropriate terminals. Use the scew to fix the top.
In the figure at the end of manual, you can see different types of installation, in the center of the window or on a side.
The drawings are for guidance only, so you should always test the sensor.
5.
WARM UP AND OPERATION
At start up the sensor needs a warm up time, this time is about 40’’.
During this time, the sensor it must not detect movimentation.
The WARM UP is represented from internal and external blink LEDs
Once you have finished this, you may perform the coverage tests.
To Next Page
Loading...
Need help?
General