AIR FILTER
WATER DRAINAGE
AGE
MAINTENANCE
CLEANING
Clean the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage.
End of Season Maintenance
：
9
1.
Manual drainage:
1.1 When the internal water tank is full the unit will stop working.
from internal water tank.
1.3 Place a tray under the water plug.
1.5 Put the water blocker back and screw the water plug back into place.
2. Continuous drainage:
2.2 Use a water pipe to connect to the water outlet.
2.3 You can plumb this pipe into your current plumbing system, lead it outside or use a water pump.
.
Air filter cleaning
℃) water with a neutral detergent.
d) Rinse it and then dry it thoroughly.
1. Pull out the plug from the drainage hole and empty the internal tank. You can also drain the water by leaning
the unit.
2. Then switch the unit to Fan mode, and hold the button down for 5 seconds until it reaches a low fan speed.
3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to keep the inside of the unit
dry and prevents mold developing
5. Coil the wire and bind it together, then put it into the accessories space.
6. Separate the air-exhausted pipe and store it safely.
7. Cover the unit and keep it in a dry place.
8. Take the batteries out of remote control and store or dispose them safely
Note: This model has a self-evaporative function, which reduces the need to empty the water tank.
If the unit is vented correctly most of the water is reused to cool the condenser coils and any excess
is evaporated. Please do not use continuous drainage if you intend to use the self-evaporating
facility. This procedure improves cooling efficiency and also saves energy.
To Next Page
Loading...
