7
1. PLACE warmer onto a stable, flat, horizontal surface.
2. PLUG the power cord into the power source.
3. CONNECT the power cord into the back of the warmer device.
1. FLIP the rear power switch into the “ON” position.
2. PRESS and HOLD the bottom navigation button.
3. FOLLOW the on-screen instructions to ENTER up to 5 spaces
for Room, up to 5 spaces for Bed and up to 5 spaces for Pod:
• +abc/123
• =return to previous entry
• -abc/123
• Enter button=advance to next entry
• On/Off button=edits complete, return to Standby mode
STANDBY MODE
The Penguin Nutritional Warmer will be in Standby mode and cycle through
the following screens whenever powered on and not warming:
4.1 PREPARING THE WARMER
4.2 CUSTOMIZING ROOM/BED/POD INFORMATION
4.3 MODES
To Next Page
Loading...
Need help?
General