9
THAW COMPLETE MODE
OVERTIME MODE Fridge to Feed and Frozen to Feed only
When the Thaw feature is used, the feeding should be removed
immediately upon completion to prevent over-warming. The
warmer emits a ready tone. The heater immediately shuts off,
and milk must be refrigerated. The screen background will
turn green and the phrase shown will appear on the screen.
WARNING Milk must be refrigerated immediately.
After 30 minutes in Ready to Feed HOLD TIME, the warmer
will enter Overtime. Warming and vibration will turn off. The
screen background will turn red and the word “Overtime” will
appear in the middle of the screen.
The Overtime screen will remain on until the unit is turned off or is returned to Standby by
PUSHING the On/Off button or Enter button.
Note: As the manufacturer, we recommend not using the feeding after the 30 minute hold time,
but that feeding should be handled according to the hospital policy.
DISPLAYED ERRORS
If the Penguin Nutritional Warmer encounters an error, the error will be displayed on a red
screen with a warning tone. If this should occur, discontinue use of the warmer and call Ameda
CustomerCare at 1.877.99.AMEDA (26332).
1. At the beginning of a shift, take out one Therma-Liner per user.
2. Using a permanent marker, enter the following information onto the Therma-Liner:
a. Patient Information b. Date/Time c. Information
3. Open the water compartment (blue zipper) and fill to water line using room temperature water.
4. Pinch one end of the blue zipper between your thumb and forefinger and slide down the length
of the zipper to close the water compartment.
5. Repeat to ensure a proper seal. This compartment will remain sealed for the duration of the 12
hour shift.
Note: Use care when removing and re-inserting milk container
to prevent damage to interior of water compartment.
To Next Page
Loading...
Need help?
General