4209-41 08-06-21 Technical Support: 1-320-286-3500 1-800-363-0251 support@amerec.com Page 8
K2 Steamer Control and App
Install/Operating Instructions
General Information (continued)
Light Option The LED lights use a special control circuit to give you good control of their appearance. The circuits are
dedicated to Amerec’s Spectra LEDs and must not be used with any other LED or Light.
• When rst turned on, the lights will always start as White.
• On the K2: Turn the lights on by tapping the light icon. To turn them o again, scroll through to the end of the colors
or press the icon for about 3 seconds. Note: the lights do not turn o automatically, they must be turned o manually.
• The K2 can change the LEDs colors (in sequence): press the icon quickly to step through White - Red - Green - Blue -
Yellow - Aqua - Purple - Rotating colors - O.
• The K2 may be used to dim the lights. On the K2, turn the lights on then use the + and - to adjust the brightness up or
down. The light output can be adjusted to 25, 50, 75 or 100% of full brightness. The app cannot adjust brightness.
• On the App: Turn the lights on by tapping the Light Option’s icon the choose a color from the settings. To turn them o
again, press the then choose O in the settings. Note: the lights do not turn o automatically; they must be turned o
manually.
• The App can change the LEDs colors (in sequence) using the settings to step through O - White - Red - Green - Blue -
Yellow - Aqua - Purple - Rotating colors
Delayed Start can be set to begin at a later time, such as setting it before going to sleep so it is ready to use when you get
up in the morning. Start times are settable for up to 24 hours and must be re-set for each session. Always make sure the
steam room is ready for a bath before starting a delay: no towels in the room, door closed, and so on.
• Default delay is 1 hour
• Delay times can only be set after turning the bath on. Once the delay is started,
• the K2 will alternately show the remaining time before the bath is scheduled to start and
• the app will continue to show that the bath is on and the delay settings will scroll down in
1 hour and in 5 minute steps
• K2 Delay time is adjustable from 15 minutes to 24 hours in 15 minute steps
• App delay time minutes are adjustable from 5 to 60 minutes in 5 minute steps and delay hours are
adjustable from 1 to 24 hours in 1 hour steps
Technical Support
575 Cokato St E
Cokato, MN 55321
Phone 320-286-3500
1-800-363-0251
email: support@amerec.com
To Previous Page
Loading...