Installation
American Panel Corporation equipment has been shipped in a package designed to sufficiently protect from
damage under normal shipping circumstances. Upon receiving the shipment, carefully inspect the package
for visible damage and check the number of packages against the Bill of Lading. Notify the carrier immedi-
ately of any shortage or damage to your shipment. Claims must be filed promptly with the carrier.
After receipt of shipment, carefully and safely remove the unit from the package. Check the contents of the
package against the packing list. Under no circumstances may a damaged piece of equipment be returned to
American Panel Corporation without first obtaining written permission.
To assure proper installation carefully read and comply with the following instructions.
WARNING - Please read the entire installation procedure before attempting to install the unit. Failure
to follow the procedures listed in this manual may result in voiding the warranty.
IMPORTANT - Due to the size and weight of this equipment, a minimum of two people are required to
install this equipment safely. All OSHA regulations must be followed while on the job site.
Typical Areas of Responsibility
Responsibility Trade Item
Site Preparation
Refrigeration Installation
Electrical
Plumbing
Refrigeration Start-Up
Service
Warranty
General Contractor
Equipment Dealer or
Sub-Contractor
Electrical Contractor
Plumbing Contractor
Refrigeration Contractor
Refrigeration Contractor
American Panel
Corporation
Area where the cabinet is to be
installed
Run condensate drain lines
Hang evaporators, run refrigerant
lines, set condensing units
Connect power to refrigeration
systems, connect power to door
circuits for the light, heater wire
and any other electrical accesso-
ries
Start up system and check opera-
tion
30-Day, 90-Day or 1-Year Refrig-
eration Labor Service Policy
(Optional)
10-Year Panel Warranty
1-Year Refrigeration Parts Warr.
5-Year Compressor Warranty
3
To Next Page
Loading...
