Why won't my American Sanders OBS-18 motor start?
The motor might not start due to several reasons. First, check the power supply and connection to ensure the sander is receiving power. Second, make sure the interlock is depressed before activating the control lever. If these steps don't resolve the issue, there may be a defective switch or bad connection, which requires contacting an authorized Clarke American Sanders Dealer.
What to do if the fuse or circuit breaker repeatedly trips on my American Sanders OBS-18?
If the fuse or circuit breaker trips repeatedly, it could be due to low voltage or a bad connection. Try eliminating any extension cords and locate the power source closer to the work site. If the problem persists, have the voltage checked by a qualified electrician, as there may be a defective motor.
What to do if the surface remains rough after a finishing cut with my American Sanders OBS-18?
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive, such as 80-100 grit.
How to fix a motor that fails to start or runs sluggish on an American Sanders Sander?
A motor that fails to start or runs sluggishly may be due to several factors. It could be low voltage from an excessively long or undersized extension cord; use a 14 Ga extension cord, not exceeding 50' in length. Alternatively, there may be a defective start capacitor, start switch, start/run capacitor, or the motor itself may be defective. In any of these cases, it is best to contact an authorized Clarke American Sanders Dealer.
Notice of chemicals known to cause cancer, birth defects, or reproductive harm.
Details DANGER, WARNING, and CAUTION statements for safe operation.
Specific safety advice for sanding, including maintenance and part replacement.
Further safety guidelines covering PPE, dust, and general operation.
Instructions for safely moving the machine, including lifting and securing.
Essential information on grounding and electrical connection for shock prevention.
Guidance on abrasive selection for different sanding stages and floor finishes.
Steps to follow for obtaining warranty repairs and support.
Requirements for claiming warranty reimbursement for parts and labor.
Legal notice limiting manufacturer liability for indirect or consequential damages.
General| Model | OBS-18 |
|---|---|
| Category | Sander |
| Power Source | Electric |
| Voltage | 120V |
| Dust Port | Yes |
| Orbit Diameter | 1/8 in (3.2 mm) |
| Dust Collection | Optional |
To Next Page
