What to do if my American Sanders RS-16DC HDTR Sander does not run?
If your American Sanders sander isn't running, first ensure the machine is properly connected to both the machine and the wall outlet. Next, check the building circuit breaker. If problems persist, it may be necessary to call for service.
Why does my American Sanders RS-16DC HDTR Sander wobble during operation?
There are several reasons why your American Sanders sander might wobble during operation. It could be due to a defective pad where one side is denser than the other, or the pad may have taken a set from the machine sitting on it for too long. Additionally, the pad might not be seated correctly in the pad holder bristles, or the block on the brush or padholder could be warped. In the first two cases, replace the pad. If the pad is not seated properly, reseat it. If the block is warped, replace it.
Crucial safety guidelines for operating the sander.
Comprehensive safety rules for power tool operation.
Precautions related to electricity and power tools.
Specific safety advice for sanding tasks.
Information on preventing and reacting to kickback.
Step-by-step guide on how to operate the sander.
Overview of the limited warranty terms.
Conditions and requirements for warranty eligibility.
Lists items and conditions not covered by the warranty.
Procedures for warranty claims and reimbursement.
General| Model | RS-16DC HDTR |
|---|---|
| Category | Sander |
| Motor Power | 1.5 HP |
| Amperage | 15 A |
| Dust Port | Yes |
| Pad/Disc Size | 16 inch |
To Next Page
