American Standard SPECTRA+ HANDHELD User Manual

- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Thank you for selecting American Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly-please read
these instructions carefully before you begin.
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing
supply stores. It is essential that the tools and materials be on hand before work is begun.
M965854 (8/17)
SPECTRA+ HANDHELD
™
KIT
Adjustable Personal
Hand Shower Bar
For all Models
ROUGHING-IN DIMENSIONS:
• For reference
30-1/8"
(765 mm)
1-9/16" DIA
(40 mm)
1-3/4"
(45 mm)
FINISHED
WALL
WALL SUPPLY
WITH BUILT IN
BACK FLOW
PREVENTER
1/2"
(13 mm)
1-1/16"
(26 mm)
1-7/16"
(37 mm)
1/2 N.P.T.
(13 mm)
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
(1219 - 1524 mm)
RUBBER GASKET
FINISHED WALL
1/2" NPSM HOSE
CONNECTION (13 mm)
59"
(1499 mm)
9-15/16"
(252 mm)
1-3/4"
(43 mm)
DrillFlat Blade Screwdriver Level
10'
Tape Measure
CARE AND CLEANING
Do: Simply rinse the product clean with clear water, dry with a soft cotton flannel cloth.
Do Not: Clean the product with soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
INSTALLATION
INSTRUCTIONS
Certied to comply with ANSI A112.18.1M

American Standard SPECTRA+ HANDHELD Specifications

General

Type	Handheld Showerhead
Brand	American Standard
Flow Rate	1.8 GPM
Finish	Chrome
Material	Plastic
Hose Length	60 inches
Mounting Type	Wall Mount
Warranty	Limited Lifetime

Summary

Install Wall Anchors

Prepare Mounting Location

Determine desired height and mark the top center line. Use a level to mark the vertical center line for two mounting locations 30" apart.

Install Adjustable Shower Bar

Secure Shower Rail

Remove cap, secure shower rail to wall with mounting screws, then tighten fully. Reinstall cap.

Install Wall Supply

Connect Supply Nipple

Supply to wall is 1/2" NPT. Apply sealant or tape to threads of the 1/2" NPT supply nipple.

Install Hose and Hand Shower

Connect and Adjust Hand Shower

Flush lines, then attach hand shower. Use knob to adjust height on slide bar.