- 1 -
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2018
Thank you for selecting American Standard...
the benchmark of fine quality for over 140 years.
RECOMMENDED TOOLS
M965930 Rev. 1.0 (8/18)
ROUGHING-IN DIMENSIONS
STUDIO
®
S
PRESSURE BALANCE BATH
AND SHOWER TRIM KIT
INSTALLATION
INSTRUCTIONS
TU105500
TU105501
TU105502
TU105507
TU105508
Plumbers’ Putty
or Caulking
Adjustable Wrench Channel Locks
Phillips Screwdriver
• To assure proper positioning in relation to wall.
Note roughing-in dimensions.
H
C
OFF
Teon Tape
Flat Blade Screwdriver
4"
(102 mm)
BOTTOM OF TUB
FOR HEAD
CLEARANCE
18" (457 mm)
OPTIONAL
6-1/8" REF.
(155 mm)
1/2" (12 mm) NPT
1/2" (13 mm)
COPPER
7-1/2" DIA.
(185 mm)
OPTIONAL TO FINISHED
FLOOR USUALLY
BETWEEN 65'' AND 80''
(1651 AND 2032 mm)
TOP OF TUB RIM
1-5/8" TO 3-1/4"
(41 TO 83 mm)
1-5/8" TO 3-1/4"
(41 TO 83 mm)
FINISHED WALL
4-1/2"
(114 mm) REF.
11-7/8" (301 mm) REF.
2-1/8"
(54 mm)
8"
(203 mm)
1-1/2" REF.
(38 mm)
2-3/4" MAX. (69 mm)
1-3/4" MIN. (45 mm)
• Remove PLASTER GUARD (6)
(Keep it installed for thin wall Installation).
• Remove BONNET NUT (1) by unthreading it
Counter clockwise. Remove test CAP (2).
• Remove PROTECTIVE HOUSING (3) from
CARTRIDGE (4). Install with “UP” text on top.
• Reinstall BONNET NUT (1) onto VALVE BODY (5)
and hand tighten.
CARTRIDGE INSTALLATION
1
1
2
6
5
3
4
UP
To ensure that your installation proceeds smoothly-please
read these instructions carefully before you begin.
For use with shower heads rated at 4.9 L/min (1.3 gpm) or higher.
To Next Page
Need help?
General
