ASSEMBLY INSTRUCTIONS
1. Remove Black Cap and discard before assembly.
2. Use a Hex Wrench (G)
to attach the Table Plate
and Leg (E) to the
underside of the Tabletop
(D) with the provided Hex
Bolts (F).
Insert the Support Cylinder (A) into the center of the tabletop.
3 Set the foot cap over the hole in the Base. (C)
Insert the thicker end of the Support Cylinder into the
center hole of the Base, and press down FIRMLY.
4. Guide the open end of the Tabletop assembly over the
Support Cylinder and firmly press down on the tabletop.
To raise the tabletop, grasp the Handle and pull upward without
applying any weight. To lower, raise the handle upward and apply
weight to the tabletop.
DISASSEMBLY INSTRUCTIONS
Turn the table upside down. Hit the Metal Clip several times located in
The exact center of the bottom of the Base with a mallet or ball peen
hammer to disengage the locking mechanism. The Base will separate
from the Table Top and Support Cylinder.
To remove the Table Top from the Support Cylinder,
turn the table upside down, and strike the edge of
the Support Cylinder several times where it meets
the support leg of the tabletop. The Support
Cylinder and Table Plate and Leg will separate
with applied force.
To Previous Page
Loading...
