Amerihome BS1189 - Assembly Instruction; Support Cylinder Preparation; Attaching Seat Plate; Base Assembly Steps

A Black Cap protects the
hydraulic mechanism on
the Support Cylinder.
Place the wide end of
the Support Cylinder
into the center hole.
Remove the Black Cap and
discard it before assembly.
The Orange hydraulic
button will become visible.
Place the Foot Cap over
the center hole on the
base plate.
Press the Support
Cylinder down firmly
into the center hole.
Press the Seat onto
the narrow end of
Support Cylinder.
ASSEMBLY INSTRUCTION
To raise and lower the Seat, grasp the Handle and pull upward without applying any weight on the
Seat. To lower, grasp the Handle and pull upward while sitting on the Seat.
To disassemble, turn the stool upside down, and hit
the clip on the center of the bottom of the base with
a rubber mallet to disengage the locking
mechanism. Then, turn the stool right side up, and
lift the Seat upward, pulling the Seat Assembly off
of the Support Cylinder.
Use a wrench to attach the Seat
Plate to the underside of the Seat
with the provided bolts.
Metal Clip