Page 7<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 64001
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
6((&(%D*##,3*#
The following error messages may appear on the Display during operation:
6((&(%T&9* T,'#* ?&7'$"&8
6;;\J The reflected laser signal is too strong�
Change target or affix a white
sheet of paper to target�
6;;\]
The distance to be measured falls outside
the measuring range for this device�
Measure within the effective
measuring range (0�16’ ~ 98�43’)�
6;;\[ The reflected laser signal is too weak�
Change target or affix a white
sheet of paper to target�
6;;\M Low battery�
Replace battery� See “Battery
Replacement” on page 7below�
D,"8$*8,84*%,89%?*(Y"4"83
%S(&4*9'(*#%8&$%#/*4"2"4,77>%*Z/7,"8*9%"8%$."#%5,8',7%
5'#$%+*%/*(2&(5*9%&87>%+>%,%H',7"2"*9%$*4.8"4",81
T7*,8"83I%D,"8$*8,84*I%,89%G'+("4,$"&8
1� Wipe unit with a dry, lint-free cloth�
Do not use solvents or abrasives�
2� Remove battery if not in
use for long periods�
3� Store unit in a dry location�
4� Other than the battery, there
are no replaceable parts on this
unit� ;*/,"(#%#.&'79%+*%9&8*%
+>%,%H',7"2"*9%$*4.8"4",81
W,$$*(>%;*/7,4*5*8$
If the %sign appears on the
Display or the unit will not turn on,
the battery should be replaced�
1� Turn the unit over�
2� Remove battery cover carefully�
3� Pull batteries out of unit and
replace with same�
E&$*- Do not reverse the
polarity of the batteries�
4� Replace cover and retighten screw�
T,7"+(,$"&8
Have the Meter calibrated by a qualified technician every year�
To Next Page
Loading...
