Ametek Land System 4 Landmark Basic - 2 Specification

Page 3
User Guide Landmark Basic
Signal Processor
2 Specification
Input/Output accuracy: 0.4% of reading
Input/Output drift: 0.02% of span/°C
Signal retransmission current output: 4 to 20mA
Maximum current output load including cable: 500W
Emissivity/Non-greyness monitor accuracy: 0.2% of emissivity current
Emissivity/Non-greyness output drift: 0.02% of span/°C
Averager‘off’responsetime: 2ms(10to90%)
Averageradjustmentrange: 175msto4s(10to90%)(typical)
Peakpickeradjustmentrange: 5000%to1%span/s(typical)
Peak picker response time*: Set by averager response time
Peak picker remote reset characteristics: Activated by a contact closure
(mustbeaoatingandisolated
contact).Contactmustbeclosed
for 20ms to reset the peak picker.
Powersupply**: 24Vto30Va.c.(50to60Hz)/30V
to 45V d.c. at 200mA. The supply
must be isolated, fused and short
circuit protected.
Vibration: 1ginanyaxis,10to300Hz
Humidity: 0to99%non-condensing
Sealing: IP20 to terminals, IP40 elsewhere.
Ambienttemperature: 5to50°Cinspecication,5to60°C
operating.
EMC immunity: EN 50-082-2
EMC emission: EN 50-081-1
* The averager function precedes the peak picker function in the signal path.
** A LAND DPU mains power supply is recommended.