To Next Page

To Previous Page

BID Detect –

Charger is attempting to detect if the connected battery

contains a BID/WBID

BID Init –

Charger has established communication with the BID/WBID

and is reading ALL of the available data.

BID Refresh –

Charger is reading the latest Battery Temperature,

Battery VPC, and Accumulated Charge/Discharge data from the bat-

tery.

Mod X Over Temp –

Module #X is reporting that it is overheating.

In this scenario, the system will attempt to cool down the module by

reducing power.

Mod X IGBT Err –

Module #X is reporting a problem with

its IGBT drive

Mod X Short –

Module #X is reporting a Short Circuit condition

on its output.

Mod X Phase Loss –

Module #X is reporting a Phase Loss

Mod X Over Curr –

Module #X is reporting an overcurrent issue

Mod X Offline –

Module #X is offline and not providing power.

Hot Disconnect –

Charge cycle aborted due to disconnecting the

battery while charging.

Manual Stop –

User requested to stop the charge cycle by pressing

the red button on the front door.

Cell Validate –

The charger is determining the correct cell count for

the battery when in Multi-Cell mode.

Writing BID –

The charger is writing information to the BID.

Mod X Temp Err –

Module #X has overheated and is shutdown.

well as any warnings or engine faults.

CHARGE STATUS

Statistics will have a real-time status. Archive records will have

the termination code.

Session Start –

Charge Session started

Start Current –

Charger is providing Start Current

Gassing –

Charger is regulating voltage to the Battery

80 Percent –

Charge session has passed the 80% complete point.

Finish Current –

Charger is providing finishing current.

Lid –

Charger is modulating LID voltage (maximum charge voltage).

Charge Complete –

Charge Session Complete

High Battery –

High Battery Volts Reject Error.

Batt Over Temp –

Battery Overtemperature Error

Low Volt Shut –

Low Voltage Shutdown Error

Charge Curve Err –

Charge Curve Error

Low Curr Shut –

Low Current Shutdown

High Curr Shut –

High Current Shutdown

Backup Timer –

Session timeout due to backup timer.

Over Max AH –

Over Max AH returned.

Over Temp Err –

Charger overtemp error

DIDT Shutdown –

DiDt Shutdown error

Engine Error –

Charge Engine Error

Over Temp Warn –

Charger Cabinet is overheating, (charging power

may be reduced in this state)

Output Limited –

The charger is unable to meet the required output

Low Batt Reject –

Low Battery Volts Reject Warning

SM Inhibit –

Charging temporarily halted due to Start Mode

Batt Cycle Delay –

Multi-Cell charging delay active. This delay oc-

curs to avoid issues with the user disconnecting and reconnecting a

battery quickly when the charger is set for Multi-Cell Mode

No Gas Inhibit –

Charging is delayed due to No Gassing being active

Equalize –

Charger is currently equalizing

Refresh Started –

Charger is in a 60 second countdown to begin a

refresh.

Battery Watering –

Charger is running the battery watering routine.

Addition Charge –

Charger is running additional Finish Current

charge as specified by the customer.

BID Comm Failed –

Communication with the BID device has ended

and failed.

Brand	Ametek
Model	Deka PowerForce
Category	Battery Charger
Language	English

Ametek Deka PowerForce User Manual

Table of Contents

Questions and Answers:

Ametek Deka PowerForce Specifications

Related product manuals