3
INTRODUCTION
How To Use This Manual
IMPORTANT: It is especially important that all charger internal
components be kept clean and dry, and all electrical connec-
tions tightened. Replace any precautionary or instruction label
that cannot be easily read.
To ensure safe operation, read the entire manual, including the
chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION, and
NOTE may appear. Pay particular attention to the information
provided under these headings. These special annotations are
easily recognized as follows:
WARNING gives information regarding possible personal injury.
CAUTION refers to possible equipment damage.
NOTE offers helpful information concerning certain operating
procedures.
Equipment Identification
The unit’s identification number (specification, model, serial number)
appears on a nameplate attached to the front panel.
Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for pos-
sible damage due to shipping. If there is any damage, notify the
carrier immediately to file a claim. Furnish complete information
concerning damage claims or shipping errors to the company
shown on the cover of this manual. Include all equipment iden-
tification numbers and group part numbers (if any) as described
above, along with a full description of the parts in error.
Move the equipment to the site of installation before uncrating.
Use care to avoid damaging the equipment when using bars,
hammers, etc., to uncrate the unit.
Additional copies of this manual are available on the company
website www.eastpennmanufacturing.com.
NOTE: Information regarding obtaining additional copies of this
manual is located in the Introduction chapter of this manual.
A battery charger is identified by model number. Incorporated
into the model number is the ampere-hour capacity, module
count, and number of cells in battery for which charger is
intended. The following example explains the basic model
numbering arrangement.
NOTE: This information is required for ordering certain
replacement/service parts.
3
MODEL NUMBER 750 EB 2 18 P
Rated: P = Opportunity, F = Fast
Number of Cells
Module Count (1-8)
Case Type
Nominal AH Size
To Next Page
Loading...
