Sequoia / Tahoe Series User Manual California Instruments
106 M447352-01 REV-A
Parameter values, such as voltage and current, are adjusted by
selecting the parameter (tapping on it) to enable the selection
field (refer to Figure 5-8). If a parameter had been selected whose
value could be adjusted, and the encoder switch is depressed, a
screen will be displayed with a parameter selection-field
highlighted that has a value entry window (refer to Figure 5-9).
The rotary encoder could then be used to continuously adjust the
parameter value, up and down, as the encoder is rotated. Tap the
encoder a second time to enter the value. If the OUTPUT switch
is on, the output parameter will change when the encoder is
tapped.
The DASHBOARD screen menu has the capability for real-time
adjustment of output parameters: the value of the parameters
change as the rotary encoder is turned for immediate effect at the
output. If the OUTPUT switch is on, the output parameter will
change as the encoder is rotated. Refer to the DASHBOARD
screen menu in Section 5.6.3, for a description of the parameters
that have real-time adjustability.
Figure 5-8. Output Program Menu
3-Phase with only Phase-A selected
To Next Page
Loading...
