Sequoia / Tahoe Series User Manual California Instruments
152 M447352-01 REV-A
5.7.3 Dashboard Screen Top-Level Menu
The DASHBOARD screen top-level menu is used to change output parameters and simultaneously view
output measurements. The most commonly used output parameters are located in the DASHBOARD
screen menu. The DASHBOARD screen is the default menu that is displayed after powering on.
The top-level menu of the DASHBOARD screen is shown in Figure 5-84. It can be reached in one of two
ways:
1. Tapping DASHBOARD on the HOME Screen of the front panel touch-screen.
2. Scrolling to DASHBOARD with the encoder and depressing the encoder switch.
The UP arrow button will return to the previously selected screen menu (in this case the HOME Screen-
1). The HOME button will return to the HOME screen that has the top-level menu for the sub-menu being
displayed; for the DASHBOARD screen top-level menu, that is the HOME Screen.
3-Phase Mode
1-Phase Mode
Figure 5-84. DASHBOARD Screen Top-Level Menu
The following selections are available in the DASHBOARD screen top-level menu. Functions that accept
a numeric value require that the value is within the allowed range, otherwise, an error will be generated,
and the value will not be accepted.
When the unit is configured for 3-Phase output, each phase has individual settings. When the unit is
configured for 1-Phase output, only Phase-A is displayed. Tapping on a phase button toggles the selection
of that phase for inputting values. When a phase is selected, its button is displayed with a green color.
To Next Page
Loading...
