Sequoia / Tahoe Series User Manual California Instruments
242 M447352-01 REV-A
Figure 5-268. LCD Settings
Calibration Enables the calibration routine for the display touch-screen; the
calibration is run by tapping the displayed target, as instructed on
the display. The touch-screen depends on pressure being
applied to the top surface of the screen to detect the position of
the input. A fingertip, fingernail, or stylus pen could be used. To
prevent scratching the surface layer, do not use a hard or sharp
tip, such as a ball-point pen or mechanical pencil settings for the
LCD brightness and calibration of the display.
Figure 5-269: Calibration Screen
5.14 Warning/Fault Screen
The following warning screen may appear during supply fault conditions, refer to Figure 5-270. Pressing
on the OK warning screen will be closed. The user should Clear the Fault to continue the operations of the
power supply and clear the fault.
These warnings indicate a description of Faults which has occurred in a power module. These conditions
might clear themselves, however, if they continue to occur after sending the clear Fault command; Contact
the factory for service assistance.
To Next Page
Loading...
