EasyManua.ls Logo

Ametek SEQUOIA Series - Page 81

Ametek SEQUOIA Series
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Sequoia / Tahoe Series User Manual California Instruments
58 M447352-01 REV-A
NOTE: SYNC input is not supported in SINK-Electronic Load operating mode
LKS (Option)
Signal inputs for Auxiliary Clock and Logic signals used in synchronizing two or
more AC sources;
logic level, TTL-compatible;
rear panel BNC connectors for each signal;
safety isolation SELV-rated, referenced to chassis.
NOTE: SYNC input is not supported in SINK-Electronic Load operating mode.
Table 3-15: Trigger Output Function
3.8.3 External I/O Control Signal Connector
The External Input/Output connector, EXT IN/OUT, is located on the rear panel. Figure 3-14 shows the
rear panel view of the connector, Table 3-16 lists the connector type. Table 3-17 shows the functions and
Table 3-18 shows the connector pinout.
Figure 3-14. External Input/Output Control Connector
Connector Type
External Input/Output Control High-density, 15-socket, receptacle (female) Subminiature-D.
Table 3-16. External Input/Output Control Connector Type
Function Characteristics
External Analog
Modulation of
Output Voltage
Signal input for output voltage modulation of waveform set by internal controller reference;
0-5 V(RMS) signal range for 0-10% of full-scale output voltage amplitude modulation;
programming accuracy, ±2% of full-scale output;
individual inputs provided for each output phase; input impedance, 40 k, typical;
safety isolation SELV-rated, referenced to chassis.
NOTE: External Analog waveform modulation function is not supported in SINK- Electronic
Load mode
Trigger Input
Signal input for external trigger for execution of programmed value;
logic level, TTL-compatible;
Signal return common to signals, Trigger input, Synchronization Clock and Remote Inhibit;
safety isolation SELV-rated.
Synchronization
Signal (SYNC)
Input
Signal input for external square wave clock to control the output frequency and phase of
the waveform generated by the internal generator;
logic level, TTL-compatible;
Signal return common to signals, Trigger input, Synchronization Clock and Remote Inhibit;

Other manuals for Ametek SEQUOIA Series

Related product manuals