What to do if nothing happens when I switch on my Amewi AMXFlight AFX-PD100 Toy helicopter?
If nothing happens when you switch on the Amewi Toy helicopter, it could be due to several reasons: * The flight battery is empty. Check the voltage of the battery and charge the battery. * The batteries on the remote control are empty. Replace the transmitter batteries. * The remote control is off. Switch on the remote control.
What to do if my Amewi AMXFlight AFX-PD100 helicopter vibrates strongly?
If your Amewi Toy helicopter vibrates strongly, it could be due to several reasons: the rotor blades are deformed, the shaft is bent, the tail rotor is bent, the shaft of the tail motor is bent, or the screws on the rotor blade mounts are too tight. To resolve this, try the following: * Replace the rotor blades. * Replace the shaft. * Replace the tail rotor. * Replace the tail motor. * Loosen the screws on the main rotors.
What to do if Amewi Toy helicopter drifts in one direction?
If the Amewi Toy helicopter drifts in one direction, the servos may need adjustment. Trim the servos on the remote control as described in the instructions.
What to do if my Amewi Toy helicopter turns to the left after takeoff?
If the Amewi Toy helicopter turns to the left after takeoff, the tail motor might not have enough power, or the tail rotor or tail motor could be defective. Check the connection of the tail motor and the tail rotor. If they are defective, replace them.
What to do if my Amewi AMXFlight AFX-PD100 Toy helicopter doesn't fly in all directions?
If the Amewi Toy helicopter does not fly in all directions, the servo might be defective. Replace the defective servo.
What to do if Amewi Toy helicopter and remote are not connected?
If the helicopter and remote control are switched on, the LED at the tail is flashing, but there is no function, it means that helicopter and remote control are not connected. Reconnect the helicopter and the remote control.
Charging the battery using the USB port on a computer.
Charging the battery using a power supply adapter.
Charging the battery using a power bank.
Instructions for removing and mounting rotor blades.
Procedure for dismantling and replacing the tail section.
Guidance on replacing the main gear and ensuring vertical tail alignment.
To Next Page
General