13
Picture 7
Picture 8 Picture 9
Check before sailing
2. Don’t fold the water-cooling hose and
keep it smooth inside.
3. Twist the rudder knob towards counterclockwise, the steering gear will turn left
(Picture 8); Twist the Rudder Knob clockwise, the steering gear will turn right
(Picture 9).
4. Make sure that the boat cover is locked up and buckled. Make sure that the tail
rubber stopper is tight to prevent the water from entering.
amewi.com
1. Check the rotation direction of propeller once power on. ( Picture 7).
Pull back the throttle trigger of transmitter slowly,
the propeller will spin counterclockwise.
Push forward the throttle trigger slowly,
the propeller will spin clockwise.
5. Use the provided screw driver and wrench to fix the screws and ensure that all
screws are fixed and tight.
6. Make sure the power plug and battery wire are connected correctly and tightly.
Keep the battery wire to the boat side to avoid it touching the motor.
Calibration
After a period of sailing, it may be difficult in control if the trimming is unavailable
in direction. Please carry out the following procedures to calibrate the direction.
1. After pairing the frequency, if the steering gear is
not vertically upward (Tolerance within 10° is in
the normal range.)（Picture 10）, please refer
to the instruction for steering gear replacement
on page 14 and then calibrate the steering gear.
Picture 10
To Next Page