AmFor 881 User Manual

00
200200
100100
5050
150150
STARTER
AMPS
STARTER
AMPS
00
22
44
66
88
1010
MILLIAMPERE
METER
MILLIAMPERE
METER
00
00
3030
3030
1010
1010
2020
2020
ALTERNATOR
VOLTAGE
ALTERNATOR
VOLTAGE
STARTER / STATOR
VOLTAGE
STARTER / STATOR
VOLTAGE
00
3030
1010
2020
ALTERNATOR
AMPS
ALTERNATOR
AMPS
STARTER VOLTAGE
STATOR VOLTAGE
0
STARTER VOLTAGE
STATOR VOLTAGE
0
STARTER AMPERAGE
0
STARTER AMPERAGE
0
4
a
m
p
4
a
m
p
BlueBlue
GreenGreen
RedRed
BAD DIODE LIGHT CHARGE LIGHT AUXILIARY LIGHTBAD DIODE LIGHT CHARGE LIGHT AUXILIARY LIGHT
MILLIAMPERE METER
6 or less
MILLIAMPERE METER
6 or less
ALTERNATOR VOLTAGE
13 to 16
ALTERNATOR VOLTAGE
13 to 16
ALTERNATOR AMPERAGE
12 to 16
ALTERNATOR AMPERAGE
12 to 16
offoff
offoff
offoff
Test Lead A
Test LeadsTest Leads
and
881 Alternator
Starter Test Bench
Many alternators use the same plug with different wiring. Please
refer to test lead chart for the correct test lead requirements!
1. Readings for a good alternator are in the shaded area. All meter
readings are ±5%.
2. Insert lead as shown below and slide alternator onto alternator
holder pin.
3. Install the belt on to the alternator pulley. Make sure the belt is
under the motor pulley belt retaining clip. Slide the green handle
to the right, locking the handle into the retaining tab and close the
belt guard. Make sure to keep your fingers and clothing free of
the pulley and belt.
4.Turn on motor switch. The charge light on the panel should be lit.
If not, check and reset the circuit breaker on the front panel.
5. Press the GREEN test button MOMENTARILY and RELEASE
(hold for no more than 3 seconds). Observe meters for proper
readings.
Red clip
pdc/nwr/inv/881/881-manual/green/889-A.cdr
Black clip

AmFor 881 Specifications

General

Brand	AmFor
Model	881
Category	Test Equipment
Language	English

Summary

Alternator Test Lead Guide

Test Lead A

Diagram showing connection and usage instructions for Test Lead A.

Test Lead B

Diagram showing connection and usage instructions for Test Lead B.

Test Lead BD

Diagram showing connection and usage instructions for Test Lead BD.

Test Lead BM

Diagram showing connection and usage instructions for Test Lead BM.

Test Lead BT

Diagram showing connection and usage instructions for Test Lead BT.

Test Lead C

Diagram showing connection and usage instructions for Test Lead C.

Test Lead CD

Diagram showing connection and usage instructions for Test Lead CD.

Test Lead D

Diagram showing connection and usage instructions for Test Lead D.

Test Lead EL1

Diagram showing connection and usage instructions for Test Lead EL1.

Test Lead EL2

Diagram showing connection and usage instructions for Test Lead EL2.

Test Lead EL3

Diagram showing connection and usage instructions for Test Lead EL3.

Test Lead EL4

Diagram showing connection and usage instructions for Test Lead EL4.

Test Lead F

Diagram showing connection and usage instructions for Test Lead F.

Test Lead FA

Diagram showing connection and usage instructions for Test Lead FA.

Test Lead FB

Test Lead FC

Test Lead FT

Test Lead FV

Test Lead G

Test Lead H

Test Lead HL

Test Lead ID

Test Lead IG

Test Lead IN

Test Lead J

Test Lead JD

Test Lead K

Test Lead LR

Test Lead M

Test Lead MD

Test Lead N (A Circuit)

Test Lead N (B Circuit)

Test Lead P

Test Lead S

Test Lead SC

Test Lead SI

Test Lead SJ

Test Lead SK

Test Lead SL

Test Lead SN

Test Lead T

Test Lead TD

Test Lead U

Test Lead V

Test Lead VO

Test Lead VW

Test Lead WF

Test Lead Y