23
ERROR CODE
DESCRIPTION OF THE
FAULT
ACTION
The Rapid light icker eetly Longer water inlet time
Faucets is not opened, or water
intake is restricted,or water pressure
is too low.
The Rapid light and the 90Min
light icker eetly
Not reaching required tem-
perature.
Malfunction of heating element.
The Glass light icker eetly Overow Some dishwasher element leaks.
One of programme indicators lights up and the
Start/Pause indicator ashes
• The dishwasher door is open — close the
door.
If the programme won't start
• Make sure the plug is properly inserted into
the wall outlet.
• Check the fuses in the electrical system
• Make sure that the water supply valve is open.
• Make sure that the door is closed.
• Make sure that the dishwasher is turned off by
pressing the On/Off button.
• Make sure that the water supply lter and dish-
washer lters are clean.
If the indicators do not go out after washing
• You did not press the On/Off button.
• If the there is residue detergent in the dis-
penser
• Detergent was added to wet dispenser.
If there is water in the dishwasher when pro-
gramme completes
• Water drain hose is clogged or kinked.
ERROR CODES AND TROUBLESHOOTING
• The lters are clogged.
• The programme not yet completed.
The dishwasher stops during a washing pro-
gramme
• Power failure.
• No water supply;
• The program can be paused.
You can hear clinking noises inside the appli-
ance
• The dishes are arranged incorrectly.
• Spray arm hits the dishes.
If food residue remains on the dishes
• Dishes are improperly loaded into the dish-
washer and the water does not reach every-
where.
• Basket overloaded.
• The dishes touch one another.
• A very small amount of detergent was added.
• Unsuitable, gentle washing programme se-
lected.
• Spray arm clogged with food residue.
• Clogged lters.
• Filters improperly tted.
• Drain pump clogged.
If white spots or streaks appear on the dishes
• Very small amount of detergent was added.
• Low dose of rinse aid.
• You are not using special salt, in spite of the
Programme indicators:
a) all indicators off — standby
b) one programme indicator lights steady — programme paused pause or waiting to start the
programme
c) one indicator ashing — programme in progress, the appliance operates
d) an indicator is ashing fast — error (see the following table)
To Next Page
Loading...
Need help?
General
