87
OPERATION
Before using the oven for the rst time
Remove packaging, clean the interior of
the oven,
Take out and wash the oven ttings with
warm water and a little washing-up liquid,
Switch on the ventilation in the room or
open a window,
Gently press the knob and turn it right to
position or (see section: electronic
programmer operation and oven control),
Heat up the oven (to a temperature of
250°C for approximately 30 minutes),
remove any stains and wash the interior
carefully.
Important!
To clean the oven, only use a cloth
well rang out with warm water to
which a little washing-up liquid has
been added.
The electronic prgrammer is equipped
with electronic sensors which are swit-
ched on by touching or pressing the
sensor surface for at least one second.
Each sensor reaction is conrmed by
the beep.Keep the sensor surface clean
at all times.
Important!
In ovens equipped with the electronic
programmer, the time “0.00” will start
ashing in the display eld upon con-
nection to the power supply.
The programmer should be set with
the current time. (See Electronic
programmer ). If the current time
is not set operation of the oven is
impossible.
To Next Page
Loading...
