Why does my Amiko Set-top boxes say no signal?
A 'No signal' message on your Amiko Set-top box might appear if the signal level is weak, the LNB is out of order, the cable from the LNB is incorrectly connected (short circuit or open circuit), or the dish position is aligned incorrectly.
Why is there no picture on my Amiko Set-top boxes screen?
If there is no picture on the screen when using your Amiko Set-top boxes, the receiver might be in Standby mode. Also, check if the RCA jack or cable is not connected firmly to the video output port of the television, ensure the correct channel or video output is selected on the television, or verify that the brightness level of your TV set is correctly defined.
General| HDMI Output | Yes |
|---|---|
| USB Ports | Yes |
| Ethernet Port | Yes |
| Operating System | Linux |
| WiFi | 802.11 b/g/n |
| Video Resolution | Up to 1080p |
| USB Ports Count | 2 |
| Model | Mira WiFi |
| Type | Set-top box |
| Connectivity | WiFi, Ethernet |
| Connectors | HDMI, USB, Ethernet |
| Ethernet | 10/100 Mbps |
| Supported Video Formats | MPEG-2, H.264 |
| Supported Audio Formats | MP3, AAC |
To Next Page
