or skin dryness, please replenish the gel promptly)
[Eye care mode] for 4 minutes. Start the RF device and select [eye care mode] “ ”
● Apply AMIRO BEAUTY Gel or eye mask around the eyes
● Place the RF device on the left eye area and glide. When using the device for the first time or after not using it for a long period,
start with the lowest intensity to build tolerance (see illustrations below)
● After the second brief vibration, move the device onto the right cheek
[Full face anti-aging mode] The whole care process is about 5 minutes. Turn on the radio frequency instrument, and select [full face
anti-aging mode] " ."
● Apply AMIRO BEAUTY Gel evenly on the entire face or place a face and neck mask on the jawline area
● Place the RF device on the V-shaped face mask area and glide. When using the device for the first time or after not using it for a
long period, start with the lowest intensity to build tolerance (see illustrations below)
● Move the device to the left cheek area after the first brief vibration, to the right cheek after the second brief vibration and to the
forehead after the third short vibration.
● When the device vibrates for 1 second and is powered off, the treatment mode is finished. Switch it on again if you need to
continue using it.
Step 4: Cleansing and hydrating
● After the care routine, wash your face with clean water and apply skin care products if needed.
Step 5: Device maintenance
● After treatment, wipe off any gel remaining on the RF device with a slightly damp soft cloth, then dry it with a dry cloth before
putting it back in a box or storage bag.
To Next Page
Loading...