EasyManua.ls Logo

Amiro R1 - Operating Procedure; Charging; Powering On and Off; Switching Modes

Default Icon
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating procedure
1. Charging
Insert the Type-C connector of the charging cable into the device's charging port.
The device is fully charged when all 5 intensity/power indicators are lit.
**The device cannot be used when charging.
**Lay the device down when charging to prevent it tipping over.
2. Powering on and off
When powered on for the first time, the device will be in default eye care mode. The device will be in the last-used mode when it is
powered on again.
The device will automatically turn off if no operation and no contact with skin are made within 120 seconds after being powered
on.
Long press the power/mode button for 2s to power off the device.
3. Switching modes
When power is on, short press the power/mode button to switch between [eye care mode] indicated by " " and [full face
anti-aging mode] indicated by " ".
4. Selecting intensity
The default intensity is 1 (1 light on) when first powered on; it remembers the last intensity used when it is next powered on.
After powering on the device, short press the “+” button to increase intensity and the “-” button to decrease intensity.
The highest intensity is 5 (5 lights on), and the lowest is 1 (1 light on).
5. Power indicator
The device does not display remaining power when powered on or used.
Press the [power/mode button] to check the [intensity/power] indicator for remaining power when powered off. 5 indicators
indicate the highest power level and 1 indicator indicates the lowest.
6. Low battery and power shortage warnings
In powered-on or standby states, the corresponding indicator will keep flashing when power is low. Please charge regularly to
ensure smooth use.
When powered off, the power is low if the device cannot be turned on by pressing the power/mode button and the Level 1 indicator
flashes 5 times before going out. Please charge immediately to ensure normal operation.
Care advice
[Eye care mode]: It is recommended to use 2-3 times per week, in combination with AMIRO BEAUTY Gel or eye mask.
Usage sequence: Left eye area and right eye area for 2 minutes each, 4 minutes in total.
[Full face anti-aging mode]: It is recommended to use 2-3 times per week, in combination with AMIRO BEAUTY Gel or
facial and neck mask. Usage sequence: V-shaped face mask for 2 minutes, left cheek for 1 minute, right cheek for 1 minute,
forehead for 1 minute, 5 minutes.
Care procedure
Step 1: Makeup removal and cleansing
Remove makeup and cleanse your face to ensure your skin is clean.
Step 2: Applying the gel
Apply some recommended gel to the center of the RF electrode or the face (When you feel the resistance of the device on the face

Related product manuals