Amiro R1 - Malfunction and Maintenance; Table of Common Malfunctions

Malfunction and maintenance
Table of common malfunctions
Problem
Possible cause
Solution
Start failure
Dead battery
Charge fully before use
End of battery life
Contact the manufacturer for repair or
replacement
Automatic power off
No operation for more than 120 seconds
Restart the device
Dead battery
Charge fully before use
RF device electrodes not tightly pressed
against the skin
Keep RF device electrodes tightly pressed
against the skin
Inappropriate gel
AMIRO BEAUTY gel is recommended
Insufficient gel
Replenish gel on the face
Burning sensations of the face
High intensity
Lower intensity
RF device stays in one area
Slightly speed up RF device movement
Insufficient gel
Replenish gel on the face
Low heat
Low intensity
Increase intensity
Fast RF movement
Slightly reduce RF device movement
Inappropriate mode
Around the eyes special care mode RF
energy for the skin around the eyes
designed for the whole face lifting mode
to the current sense
Tingling caused by current
Device not pressed against the skin
Press the device against the skin
High mode intensity
Lower intensity
Redness of skin after use
Caused by RF heat
It normally recovers soon afterwards;
please seek medical attention if you don’t
recover or have other discomfort.
Warning:
Non-ionizing radiation
Read user manual