Prepare Your Camera for use
Install battery
Your camera supplied a lithium battery, please refer to the following illustration as correct installation
method:
1. Slide and open the battery compartment.
2. Insert the lithium battery correctly as the correct polarity facing up.
3. Close the battery compartment.
Note: Please uninstall your battery when you don’t intend to use your camera for a long time.
Charging your lithium battery
To charge your battery, you only need to connect your camera to PC with supplied USB cable correctly. The
LED light will light up and it will be off after full charge.
Install a SD memory card
This camera supports any compatible SD memory card up to 32GB. Limited internal memory is only for you
to take test photo, these photo will be lost when you turn off your camera or remove away the battery. So
that insert a SD memory card is normally for use. Please refer to the below diagram for correct installation.
To Next Page
Loading...