To Next PageTo Next PageWhat to do if Ammann Vibratory rammers & tampers engine stops during operation?
If your Ammann Vibratory rammers & tampers engine stops by itself during regular operation, here are a few potential causes and solutions: * **Fuel supply interruption:** Add more fuel to the tank. * **Tank run dry:** Refill the fuel tank. * **Blocked fuel filter:** Replace the fuel filter. * **Oil pressure lost:** Check the engine oil level.
How to troubleshoot reduced engine performance in Ammann Vibratory rammers & tampers?
If you're experiencing reduced engine performance with your Ammann Vibratory rammers & tampers, consider the following: * **Fuel Supply Obstruction:** Add fuel. * **Tank Run Dry:** Add fuel. * **Fuel Filter Blocked:** Renew the fuel filter. * **Inadequate Tank Venting:** Ensure the tank is adequately vented. * **Leaks at Pipe Unions:** Check the threaded pipe unions. * **Blocked Air Cleaner:** Remove dirt from the air cleaner. * **Incorrect Valve Clearance:** Adjust the valve clearance. * **Too Much Oil in Engine:** Correct the engine oil level. * **Too Much Oil in Exciter:** Check the exciter oil level.
What to do if my Ammann Vibratory rammers & tampers engine runs but the machine doesn't move?
If your Ammann Vibratory rammers & tampers engine is running but the machine isn't moving forward, the issue might be: * **Insufficient V-belt tension:** Retension the V-belt. * **Broken V-belt:** Replace the V-belt. * **Worn centrifugal clutch lining:** Replace the linings and springs. * **Too much oil in exciter:** Check the exciter oil level.
General| Brand | Ammann |
|---|---|
| Model | APR 2220 |
| Category | Vibratory rammers & tampers |
| Language | English |
