Ammann ASC 130 - Page 46

42 ASC 70 / 90 / 100 / 110 / 130 / 150 / 200 / 250
3. Repair safety instructions
Ecological precautions
Contents of machine systems and some parts of the machine can produce, when no longer in use, represent great risks to the •
environment.
The following products especially belong to this category:
both organic and synthetic lubricating materials, oils and fuel, -
coolants,
-
battery acids and batteries themselves,
-
cleaning agents and preservatives,
-
all removed lters and lter elements,
-
all used and discarded hydraulic and fuel hoses, rubber - metals and the other elements stained with the above products.
-
The above parts and materials must be handled, after they had been discarded, in accordance with valid national regulations on
•
environmental protection and according to directions concerning health protection.
When hydraulic liquids, fuel, cooling systems and their aggregates are being removed it is necessary to prevent their inltration
•
into the ground by using retaining vessels and by plugging the holes.
After leaks the place must be immediately dried with sawdust, Vapex, and such.
•
The contaminated earth must be removed to prevent further leakage. Then the soil and absorbing material must be disposed of
•
safely.
Fire precautions
The place where oil is being changed must not situated in an area where there is danger of explosion or re. •
Notices showing that smoking and open ame are not allowed must be installed there.
•
The handling area must have sucient dimensions to capture the amount of inammable liquid equal to the volume of the largest
•
vessel or the transport package.
Portable re-extinguishers must be available.
•
Oil and oil products should be handled in special vessels, e. g. metal barrels, cans, tin cans.
•
Transport vessels must be properly closed when stored.
•
The vessels should have one hole and should be always stored with the hole up and they must be secured against leakage.
•
The vessels must be labeled with indelible inscriptions showing their contents and burning power class.
•
THE STANDARD TOOLS FOR MAINTENANCE AND ADJUSTMENT ACCORDING TO THE NORM ISO 4510-1
THE SPECIAL TOOLS, ASSEMBLY JIGS SEE APPROPRIATE CHAPTERS OF THE WORKSHOP MANUAL.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com