EasyManua.ls Logo

Ammann AVH 6020 - User Manual

Ammann AVH 6020
109 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Originalbetriebsanleitung
Translation of the Original
operating instructions
Traduction du
Mode d‘emploi original
AVH 5020
AVH 5030
AVH 6020
AVH 6030
AVH 100-20
Traducción del Manual
de Instrucciones original

Table of Contents

Questions and Answers

  • J
    judywilkinsAug 10, 2025
    Why does my Ammann AVH 6020 engine not start?
    • H
      Heather EdwardsAug 10, 2025
      The engine may fail to start due to several reasons: * The speed control lever might be in the «STOP» position. If so, set the lever to the «START» position. * There might be no fuel reaching the injection pump or the tank might be empty. In both cases, add fuel. * The fuel filter could be blocked, requiring a replacement. * There may be loss of oil pressure, in this case check the engine oil level. * The feed pump may be defective and require checking.
  • C
    colleen67Aug 16, 2025
    What to do if my Ammann AVH 6020 engine stops by itself?
    • T
      Timothy GonzalezAug 17, 2025
      If your engine stops during regular operation, it could be due to: * Interrupted fuel supply or an empty tank, in which case you should add fuel. * A blocked fuel filter, which means you need to renew the fuel filter. * Loss of oil pressure, so you should check the engine oil level.
  • G
    gilbertgaryAug 25, 2025
    Why Ammann AVH 6020 engine runs, but the machine does not move forward?
    • A
      abigailjohnsonAug 25, 2025
      If the engine runs but the machine isn't moving forward, the possible causes are: * Worn centrifugal clutch lining, which means you need to replace linings and springs. * Too much oil in exciter. In this case, check exciter oil level.
  • J
    Jasmine JonesAug 31, 2025
    How to troubleshoot reduced engine performance in my Ammann AVH 6020?
    • A
      Austin StewartAug 31, 2025
      Reduced engine performance can stem from several issues: * Obstructed fuel supply or an empty tank, so you should add fuel. * A blocked fuel filter, meaning you should renew the fuel filter. * Inadequate tank venting, ensure that the tank is adequately vented. * Leaks at pipe unions, so check the threaded pipe unions. * A blocked air cleaner, remove dirt from air cleaner. * Incorrect valve clearance, adjust the valve clearance. * Too much oil in the engine, drain off engine oil down to the upper mark on the dipstick. * Too much oil in exciter, check exciter oil level.

Summary

Safety Regulations

Improper Use and Hazards

Hazards from incorrect machine operation, unauthorized changes, and control issues.

Operator Qualifications

Requirements for authorized personnel to operate the machine.

Machine Control and Handling

Safe operation of machine controls, parking, and handling.

Maintenance and Repair Safety

Safety guidelines and precautions for maintenance and repair work.

Operation

Tow-Bar Controls

Pre-Operation Checks

Essential checks and safety procedures before starting operation.

Engine Operation and Starting

Procedures for engine control, starting, and stopping.

Driving and Speed Control

Electronic Dead Mans Control (Option)

Maintenance

General Maintenance Guidelines

Lubrication and Fluid Changes

Lubrication plan and hydraulic oil change procedures.

Engine and Component Maintenance

Troubleshooting

General Troubleshooting Information

General advice and safety for troubleshooting.

Fault Diagnosis and Remedies

Common faults, their causes, and solutions.

Ammann AVH 6020 Specifications

General IconGeneral
BrandAmmann
ModelAVH 6020
CategoryPower Tool
LanguageEnglish

Related product manuals