www.amp-research.com
12/13
IM77104 rev 07.02.15
A M P R E S E A R C H P O W E R S T E P
T M
– F O R D S u p e r D u t y
Using supplied butt connectors, connect the lamp wires. Red to Red, Black to Black. Once Crimped use
heat gun to shrink tube. Close and wrap conduit with electrical tape. Secure all loose wires with cable ties.
Pull lamp wires upward to avoid any wire snagging.
Affix LED light bracket assembly to rail. Mount front light rearward of front linkage and mount rear light just
forward of rear linkage.
5
1
31
30
To Next Page