SPECIFICATIONS
Frequency coverage: 3.5—21,5 MHz amateur bands
export model Includes 10
meter band*
Power input: 1000 W PEP SSB 700 W CW
QSK: full break-in CW
Drive requirements: Typically 100 W PEP
Input impedance: 50 ohm tuned-input, low pass
pi-network type
Output impedance: adjustable pi-network, matches
50-70 ohm with SWR of 2:1 or
less.
Intermodulation distortion products: In excess
of -30 dB below PEP
Power requi refnents: 120 VAC 50/60 Hertz
15 amps or 240 VAC 50/60
Hertz 7.5 amps
Tubes: Four 6MJ6 - included with amplifier
Dimensions: W 11“ H 5.00” D 9.75”
Weight: 22 lbs.
WARNING
For proper operation of the cooling system,
the LA-1000 must be placed on a fla t smooth
surface. Do not operate on a furface such as
carpeting as this w ill impead the air flow
through the cooling holes located *n the bottom
of the chassis.
WARNING
Make no attempt to put this amplifier into
operation outside of It's cabinet. Contact with
voltages inside this amplifier can*be fatal.
To Next Page
Loading...