1
PROBLEM CORRECTIVE ACTION
Unit will not turn on.
Make sure the power washer is OFF. Plug in the electrical cord to a grounded 120 volt outlet (no
electrical extension cord should be used). If the electrical cord will not plug into your outlet, your
electrical outlet is not properly grounded and should not be used. Use another electrical outlet.
If this did not correct the problem, try plugging into another electrical outlet and repeat the above
procedure. If it is still not working, call Customer Service.
The high pressure (HP)
hose will not connect/stay
connected to the spray
gun. Is this a spray gun
problem?
the tip. Now try to insert the hose tip into the spray gun. It should “click” into place and will not come
out until the hose is released by pushing in the lever on the underside of the gun. You may cut away
the end of the sleeve with a sharp knife if unable to move the sleeve down. Be careful not to cut or
puncture the hose.
The unit is running but Power should NOT be turned on until water comes through the spray gun. Doing so will damage the
motor.
. Check the water sourc
Eject the nozzle from the lance to determine if clog is coming from the nozzle (If nozzle is clogged, see
nozzle cleaning instructions under “Cleaning nozzles”).
1.
I can’t remove the lance
from the spray gun. What
should I do?
1. All lances are attached and removed from the spray gun in the same manner. Insert the end of the
lance into the spray gun. Press the spray gun and lance together (about a 1/8 in.) and turn the collar of
the gun clockwise. The lance will lock in place. Remove the lance by reversing this procedure. Press
the spray gun and lance together and turn counter clockwise. The lance will slide out.
assembly straight down to loosen the connection, and then follow the removal process again. You may
also spray soapy water or a lubricant in the area where the lance connects to the spray gun
The power washer turns
on for
will not turn back on. Do I
have a defective unit?
1. When the water is connected, the accessories are assembled properly, and the power is turned on,
pump. The water sensor in the pump “senses” the moving water and automatically turns the power
washer on.
While you are holding the trigger open on the spray gun, at the same time, turn the power on.
TROUBLESHOOTING
If you have any questions regarding the product, please call customer service at 1-8 - - .
To Next Page
Loading...