• urn the safety lock button on the
spray gun to unlocked. While pointing the spray gun
in a safe direction, squeeze the trigger on the spray
gun until there is a steady stream of water, letting
the water and air out of the hose.
OPERATING INSTRUCTIONS
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Turn on water supply at the faucet to completely
open.
• Push the power button to turn the unit on (Green power light
will
is a normal function of the auto start feature.
• Squeeze the spray gun trigger to begin pressure washing.
• Begin power washing by squeezing the trigger on the spray
gun all the way into the handle.
• Release the spray gun trigger to stop the power washer.
• Allow the motor to come to a complete stop before squeezing
the trigger again.
• Squeezing rapidly will cause the auto start feature to miss an
trigger after rapid squeezing. Use slow, deliberate trigger pulls
to avoid this.
• Always test a small area to avoid chance of
damaging the surface.
To Next Page
Loading...