AMP TDBU REMOTE - Add or Remove Additional Remote

AMP
™
TDBU REMOTE | PROGRAMMING GUIDE
11
Add or Remove Additional Remote
1. Using Current Remote Control
2. New Remote Control
Follow instructions under the section 1.
Pair / Unpair Remote Control
Action on
Remote Control
Action on
Remote Control
Motor Response
Motor Response
a. b.
c.
Jog x1Jog x1
Jog x2
P2P2
P2
Current Remote Control
New Remote Control
Current Remote Control
*Repeat the same procedure to remove additional remote
control.
a. On the current
remote control, press Right “P2”
button until motor jog x1.
b. Once more, on the current remote control, press
Right “P2” button until motor jog x1.
c. On the New remote control, press Right “P2”
button until motor jog x2.