BA115HP/BA210 Bassamp Cube
5
10. CD INPUT: Use these RCA jacks to
connect the line level (or headphones) out-
put of a CD player, tape deck or rhythm
machine to the amplifier. The inputs to
these jacks are summed into a mono signal
which is fed into the BA115HP/BA210’s
power amplifier. The signal level from these
jacks is adjusted by the amplifier’s Master
control (#8). If the signal from the source
connected to these jacks is too strong, use
the output level control on the source to
adjust the signal to obtain the proper level
for a good mix.
11. TUNER: Use this electronic tuner to
tune your instrument. A complete descrip-
tion of the tuner is located on page 6.
12. HEADPHONES: Use this jack to listen
to the amplifier through a pair of stereo
headphones. The internal speaker is dis-
connected when the headphones jack is
used.
13. BAL. LINE OUT: This jack supplies a
post-eq, balanced line level signal for con-
necting to a house sound board, recording
unit or external amplifier.
14. POWER: Use this switch to turn the
amplifier on or off. The adjacent LED will
illuminate when the amplifier is turned on.
15. AC LINE CORD: (rear panel, not
shown) This grounded power cord is to be
plugged into a grounded power outlet,
wired to current electric codes and compat-
ible with voltage, power, and frequency
requirements stated on the rear panel. Do
not attempt to defeat the safety ground
connection.
16. HF LEVEL CONTROL: (cabinet back,
not shown): Use this control to adjust the
output level of the high frequency driver. With
the control fully counter clockwise, there is no
output from the high frequency driver. The
high frequency driver output increases as
you rotate the control clockwise.
To Next Page
Loading...
Need help?
Output and Input Levels
