6
Getting Started
1. Read and understand the included “Important Safety Instructions.”
2. Make all initial connections with the power switches OFF on all equipment. Make sure the Master Volume, Level and Gain con-
trols are all the way down.
3. Insert 9V battery or connect optional AC/DC power supply. The SCR-DI may accept the appropriate
voltage as indicated on the rear panel.
4. Connect an instrument to the Input jack with a 1/4" (shielded) instrument cable.
5. While playing the instrument, adjust the volume knob to the preferred level.
6. Adjust the EQ knobs to taste.
Technical Specifications
SCR-DI
Signal-to-Noise Ratio (20 Hz – 20 kHz) 90 dB
Maximum Gain 24 dB
Power Requirements Internal: 9V Battery / External: 9–12V DC @ 100mA
Size (H x W x D) 2.2 x 7.6 x 4.3 in / 56 x 193 x 110 mm
Weight 2.6 lb / 1.2 kg
All specifications subject to change
To Next Page
Loading...
