www.ampereelectric.co.uk
Assembling the pedals
• Each of the 2 pedals is marked on the inside to identify right (R) and left (L).
To connect the pedals to the e-bike, place the left pedal into the left pedal arm and the right pedal into
the right pedal arm (left and right directions are determined by sitting on the e-bike). Tighten by turning
the pedals toward the front wheel using a 15mm spanner.
The right pedal is attached on the same side as the chain. Make sure you check the pedals are
tight and secure before riding.
• We advise you to check all bolt are correctly tighten before the bike is used for the first time. If you have
any questions relating to this, please contact your dealer or email us at enquiries@ampereelectric.co.uk
To Next Page
Loading...
