3. Continue stabilizing the control pump
by holding the tubing (DO NOT STABILIZE
THE PUMP BY HOLDING THE UPPER,
HARDER PART OF THE PUMP DURING
THIS STEP. DOING SO WILL MAKE
PROPER ACTIVATION EXTREMELY
DIFFICULT). Give the lower part of the
pump a quick, forceful squeeze (Figure 8).
This step may need to be repeated if you’re
not successful the first time. Because greater
pressure is required for activation than for
normal operation, you may experience some
discomfort while activating the device.
The system should now function normally.
8
Figure 8
To Next Page
Loading...
