To Next PageTo Next Page
Need help?Do you have a question about the Anaheim Automation AD1200 and is the answer not in the manual?
General| Motor Type | DC |
|---|---|
| Voltage | 120 VAC |
| Maximum Door Weight | 500 lbs |
| Drive Type | Chain Drive |
| Battery Backup | No |
| Remote Control | Yes |
Adhere strictly to all steps and safety guidelines provided in the manual.
Ensure door is balanced, locks disabled, and ropes removed before installation.
Install opener at least 7ft high; control at 5ft, away from moving parts and children.
Verify door reverses on obstruction and perform safety reverse test.
Use the grounding type plug and outlet; avoid adapters and extension cords.
Understand the function of the safety reversing sensor and its importance.
Disconnect power, ensure proper bracket fastening, and clear light beam path.
Mount sensor brackets on the garage wall or door track for proper alignment.
Align sensor brackets to ensure the invisible light beam path is clear and unobstructed.
Connect sensor wires to the opener terminals and ensure proper indicator light function.
Guidelines for adjusting travel limits based on door open/close performance.
Adjust UP and DOWN force controls to ensure proper door operation and safety.
Verify the safety reversing sensor functions correctly by testing the opener's obstruction response.
Test the door's ability to reverse upon striking an obstruction on the floor.
How the opener operates based on sensor status and door position.
Set code switches on remotes to match the opener's receiver code.
Learn new remote control codes by pressing the opener's 'Smart' button.
Check power, locks, ice, springs, and motor overload for non-operation.
Check wiring connections for the door control if remote operation works.
