Analog way Pulse² - Page 31

31
7.2.2 Audio

This mode turns your Pulse² into a true 8 x 2 scaled matrix, while preserving seamless
switching capabilies.Program 1 and Program 2 outputs can be set to dierent resoluons
and rates. Switching between any of the inputs can be done with the various eects (Cut,
Fade, Slides…) and synchronized on both outputs.
In this secon, you will setup the audio of your device, you have several modes. In all modes, you have the
possibility to output the audio in AES3 or SPDIF:
NO AUDIO: the audio of your device is switched o
PRESET MODE: the standard mode of use of the device
You have two possibilies:
the sound on the output will follow the audio input of the top
layer.
• Breakaway: when breakaway is acvated, the audio on the output is
memorized into the preset. A change of preset, changes the audio on the
output. A change of content into a video layer has no eect on the audio.
ROUTING MODE: in this conguraon, simply choose an audio input to
assign it to the output. The audio conguraon remains the same during
the show.
In this example input1 is on out1 and input 2 is on out 2.
