7.2.6 Output management
A short summary of each output sengs
appears on the main page. You can see the
number of outputs, their resoluon, rate and
HDCP status.
Select an output to adjust by either clicking on
it from the column on the le, or clicking the
conguraon cog icon for that output.
Once the individual output setup page is
opened, you have access to:
choose your rate generaon mode,
internal (free-running within the unit) or
Framelock by choosing an input as a reference
input,
choose the output resoluon
format,
choose the signal ming standards, if
the mode is set to internal
the status menu will show you the current output status,
click on this buon to apply the new format/rate,
indicates the status of the aached monitor and conrms connecvity,
you can choose the type of output synchronizaon on the analog plug, for example RGsB for sync on
green, or RGBHV for separate H and V sync wires,
- FORCE DVI MODE: select this box to force the output to DVI mode instead of the default HDMI autosense
mode. When in DVI mode, no embedded audio will be transmied,
a selecon of paerns is available to test your output. These paerns will override any input
selecon that you might have.
You can choose from:
• – turns the paern o
• – displays grey bars
• – displays color bars
• Grid – displays an 8x8 box grid paern
• SMPTE bars – displays the SMPTE color bar paern
• – displays alternang black and white 1 pixel wide columns
• Centering – displays a 1 pixel wide doed line at the edge of the output (only available for computer
formats)
• – displays a 0 to 100% gradient paern.
choose the value of the icker lter to remove the icker eect on your interlaced output screen,
increase or decrease the gamma of your output,
enable/disable and see the HDCP status.
Depending on the output format chosen, only relevant sengs will appear.
Into the output secon, you will be able to manage your output resoluons, formats, sync types, test paerns,
etc. On the SETUP > OUTPUT TAB, the following screen will appear:
To Next Page
Loading...
