Left Column of Jacks
MASTER PITCH MOD
A CV here will modulate the pitch of all
three oscillators. Note, it is not calibrated. It
is ‘roughly’ one volt per octave. It is
intended for modulation rather than
controlling the synth from a CV keyboard.
VCO2 / VCO3 PITCH MOD
These are also external CV pitch control
inputs - but just to those two VCOs. Same
calibration notes as above apply.
CUTOFF MOD
A CV here will modulate the filter cutoff
frequency.
EXT CK
Feed an external clock into here if you
want external analogue gear to be the
master clock of the sequencer. The jack
can be elected using the SYNC rotary
switch and selecting EXT.
NOTE0
This is a gate signal that follows the status of MIDI Note 0.
VCO3 Triangle
Triangle audio output from VCO3 - can be also used as a LFO source.
VCO2 Square
Square audio output from VCO3 - can be also used as a LFO source.
EG1
This is envelope one CV output.
EG2
To Next Page
Loading...