When press [0K] button and Start detection, it's display interface:
Current voltage: 11.80V
Off: 11.80\./
Min: 7 26V
Min: O mS
3.6 DTC Lookup
Max: 12 46V
End: 2731 mS
The DTC Lookup function is used to search for definitions of Code
stored in the built-in Code library.
1) From the Main Menu, use the LEFT /DOWN scroll button to select
the Code Lookup and press the 0K button.
DTC Lookup
WM Readmess
Q
Review
BAT Check
DTC Lookup
Please input DTC:
POOOO
The 1st range : P.C.B,LJ
The 2nd range : O. I . 2
The Others from : O to F
Changing Data: or
Moving Cursor: or [4]
Confirmation: 0K
For manufacturer specific codes , you'll need to select a vehicle make
on an additional screen to look for DTC definitions
If definition could not be found (SAE or Manufacturer Specific), the
scan tool displays "DTC definition not found! Please refer to vehicle
service"manual !"
2) To exit to the Main Menu, press the ESC button
8
To Next Page
